VM-4DKT
Quick Start
P/N: 2 9 0 0 - 3 0 1 5 4 4 QS
Rev: 1
Scan for full manual
VM-4DKT Quick Start Guide
This guide
HELPS
you install and use your
VM-4DKT
for the first time.
www.kramerav.com/downloads/VM-4DKT
to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check
what’s in the box
VM-4DKT
1:4 4K
HDMI/DGKAT Distribution Amplifier Transmitter
4 Rubber feet
1 Quick start guide
1 Power cord and adapter
IMPORTANT NOTICE!
We highly recommend using only Kramer UNIKAT cables with these products. If using 3
rd
party shielded CAT-6A cables, both ends of the
shield must be soldered to the connectors for the products to function properly. Do not use any jumpers, unshielded wall plates or mid-
span cable connections. These extenders are not compatible with HDBaseT technologies. Prior to signal extension, ensure that the
extension line cable is lying straight and not coiled.
Step 2: Get to know your VM-4DKT
#
Feature
Function
1
STATUS LED
Red
– Power up.
Green
– Power is on.
2
ACTIVE EDID LED
The LED color indicates the active EDID type. When flashing, the state is in the
process of being activated.
Yellow
– Default EDID.
Blue
– Output-acquired EDID.
Green
– Custom EDID.
3
INPUT LED
On
– Input signal detected.
Flashing
– Source connected, but no signal detected.
4
HDMI IN Connector
Connect to an HDMI source.
5
LOOP Connector
Connect to a local HDMI display.
6
DGKAT2 OUTPUTS Connectors (x4)
Connect to a DGKat-2.0 receiver (for example,
PT-872xr
) using twisted pair cable.
7
SERVICE 3-pin terminal block
Connect to a serial controller.
8
SETUP DIP-switches
Sets the device behavior (see
9
Fan Vent
For heat ventilation.
10
12V DC Power Connector
Connect the 12V DC power adapter into the device and then connect it to the
mains.
Step 3: Mount VM-4DKT
Install VM-4DKT using one of the following methods:
•
Attach the rubber feet and place the unit on a flat
surface.
•
Ensure that the environment (e.g., maximum ambient temperature & air flow) is
compatible for the device.
•
Avoid uneven mechanical loading.
•
Appropriate consideration of equipment nameplate ratings should be used for avoiding
overloading of the circuits.
•
Reliable earthing of rack-mounted equipment should be maintained.
•
Maximum mounting height for the device is 2 meters.
