4
OUTPUT HDBT
2 Connector
OUTPUT HDBT
Connectors.
5
OUTPUT HDBT
3
Connector
6
AUDIO OUT
3.5mm Mini Jack
Connect to the analog audio acceptor.
7
REMOTE IR
3.5mm Mini Jack
For future use.
8
IR
3.5mm Mini Jack
Connect to the remote IR sensor/emitter.
9
RS-232 DATA
3-pin Terminal Block
Connect to the device to be controlled via RS-232.
10
RS-232 CONTROL
3-pin Terminal Block
Connect to the serial controller to control the
VM-212DT
.
11
REMOTE
3-pin Terminal Block
For future use.
12
SETUP
4-way DIP-switch
Used to set the device behavior (see Step 7).
13
ETHERNET
RJ-45 Connector
Connect to a remote network controller via a LAN.
14
RESET
Switch
Press and hold while powering on the device to reset to factory default parameters.
15
PROG
Mini USB Connector
Connect to a PC to perform firmware upgrades.
16
Power Connector, Fuse, and Switch
Connect to the power cord and the mains electricity.
Step 3: Install VM-212DT
Install
VM-212DT
using one of the following methods:
Remove the three screws from each side of the unit, reinsert those screws through the rack ears
and mount on a 19" rack.
Attach the rubber feet and place the unit on a flat surface.
Step 4: Connect the inputs and outputs
Always switch OFF the power on each device before connecting it to your
VM-212DT
. For best results, we recommend that
you always use Kramer high-performance cables to connect AV equipment to
VM-212DT
.
Step 5: Connect the power
Connect the power cord to
VM-212DT
and plug it into the mains electricity.
Safety Instructions
Caution:
There are no operator serviceable parts inside the unit.
Warning:
Use only the power cord that is supplied with the unit.
Warning:
Do not open the unit. High voltages can cause electrical shock! Servicing by qualified personnel only.
Warning:
Disconnect the power and unplug the unit from the wall before installing.
See
for updated safety information.
