8
VM-1H4C – Acquiring the EDID
6
Acquiring the EDID
The
VM-1H4C
is programmed with a default EDID (see
Section 9
You can acquire the EDID from:
). This lets you
connect the power before having to connect one of the acceptors. To change this
default EDID, you must acquire the new EDID from a display device.
•
One of the connected outputs (the relevant output LED lights)
•
The default EDID (all output LEDs light)
•
Up to four connected outputs using the Auto-mix Mode (all output LEDs light
in a running pattern)
This is usually done only once, when the machine is being set up in an installation.
Once acquired, the EDID is saved in non-volatile memory and further acquisition is
not necessary.
To acquire the EDID
:
1. Connect the output(s) from which you want to acquire the EDID.
2. Press the EDID SELECT button briefly.
The device enters the EDID programming mode.
3. Press the EDID SELECT button repeatedly until the required EDID is
indicated based on the patterns descr bed above.
4. Press the EDID READ button.
The relevant LEDs flash in a pattern for a few seconds as follows:
Slowly and then no longer lights. The EDID was successfully read.
Quickly and then no longer lights. The EDID was not read and the
default EDID was stored.
Содержание VM-1H4C
Страница 1: ...KRAMER ELECTRONICS LTD USER MANUAL MODEL VM 1H4C 1 4 HDMI Over CAT 5 DA P N 2900 300133 Rev 2 ...
Страница 2: ......
Страница 15: ......