Step 3: Mount VA-14
Install
VA-14
using one of the following methods:
•
Attach the rubber feet and place the unit on a flat surface.
•
Mount the unit in a rack using the recommended rack adapter
www.kramerav.com/product/VA-14
•
Ensure that the environment (e.g., maximum ambient temperature & air flow) is compatible for the device.
•
Avoid uneven mechanical loading.
•
Appropriate consideration of equipment nameplate ratings should be used for avoiding overloading of the circuits.
•
Reliable earthing of rack-mounted equipment should be maintained.
Step 4: Connect inputs and outputs
Always switch OFF the power on each device before connecting it to your
VA-14
.
1. Connect balanced audio sources and/or microphones to
the INPUT connectors.
2. Set the underside switches according to the sources for
each input.
3. Connect power amplifiers to the
OUTPUT
connectors and
connect the amplifiers to speakers.
4. Set the underside switches according to the output devices
for each output.
5. Connect the
PHONES OUTPUT
connector to a
headphone set.
Note
: For every unused input, rotate the
LEVEL
potentiometer
fully to the minimum level (counterclockwise).
To achieve specified extension distances, use the recommended Kramer cables available at
www.kramerav.com/product/VA-14
Using third-party cables may cause damage!
Step 5: Connect power
Connect the 12V DC power supply to
VA-14
and plug it into the mains electricity.
Safety Instructions (See
for updated safety information)
Caution:
•
For products with relay terminals and GPI\O ports, please refer to the permitted rating for an external connection, located next to the terminal or in the User Manual.
•
There are no operator serviceable parts inside the unit.
Warning:
•
Use only the power cord that is supplied with the unit.
•
Disconnect the power and unplug the unit from the wall before installing.
Step 6: Operate VA-14
Use a small screwdriver to adjust the audio levels:
•
For a specific input, rotate the relevant
LEVEL
potentiometer.
•
For all the inputs mixed together, rotate each of the
MASTER
potentiometers (1 and 2) respectively.
•
For the headphone set, rotate the
PHONES LEVEL
potentiometer.
