Kramer TP-900UHD, Руководство пользователя

Страница: 16 / 35

CONNECTING THE TP-900UHD
16
KRAMER ELECTRONICS, LTD.
5.3 Connecting the Ethernet Port via a Network Hub
or Switch
You can connect the Ethernet port of the TP-900UHD to the Ethernet port on a network hub using a
straight through cable with RJ-45 connectors.
5.4 RS-232 Control over HDBaseT
You can connect to the transmitter/receiver system via an RS-232 connection.
To make this connection active, it is necessary in SYSTEM PARAMETER submenu set parameter
PORT RS232 DESTINATION: to “PASS THROUGH” option.
To connect the RS-232 9-pin D-sub serial port:
• Pin 2 to the TX pin on the
TP-900UHD
RS-232 terminal block
• Pin 3 to the RX pin on the TP-900UHD RS-232 terminal block
• Pin 5 to the GND pin on the TP-900UHD RS-232 terminal block
Figure 3 shows RS-232 bidirectional control of the LCD Display by a module RC-52 that is connected to
a TP-582T.
5.5 IR Control Over HDBaseT
Since the IR signal on the TP-582T transmitter and TP-900UHD receiver is bidirectional, you can use a
remote control transmitter (that is used for controlling a peripheral device, for example, a DVD player)
to send commands (to the AV equipment) from either end of the transmitter /receiver system. To do so,
you have to use the Kramer external IR sensor on one end (P/N: 95-0104050) and the Kramer IR emitter
cable on the other end (P/N: C-A35/IRE-10)
Two IR Emitter Extension Cables are also available: a 15 meter cable and a 20 meter cable.
The example in Figure 3 illustrates how to control the DVD player that is connected to TP-582T using
a remote control, via the TP-900UHD . In this example, the External IR Sensor is connected to the IR
connector of the TP-900UHD and an IR Emitter is connected between the TP-582T and the DVD player.
The DVD remote control sends a command while pointing towards the External IR Sensor. The IR signal
passes through the TP cable and the IR Emitter to the DVD player, which responds to the command sent.