Kramer TP-752R, Руководство пользователя

Страница: 9 / 14

Kramer Electronics Ltd.
TP-752T / TP-752R – Connecting the TP-752T/TP-752R 7
Connecting the TP-752T/TP-752R
Always switch off the power to each device before connecting it to your TP-752T and
TP-752R
. After connecting your
TP-752T
and
TP-752R
, connect their power and then switch
on the power to each device.
Figure 3: Connecting the Transmitter to the Receiver
To connect the TP-752T and TP-752R as illustrated in the example in Figure 3 :
1. On the
TP-752T
:

Connect the LOOP OUT HDMI connector to an HDMI acceptor (for example, a
display)

Connect the HDMI source (for example, a Blu-ray player) to the HDMI IN
connector
.

Connect the RS-232 9-pin D-sub connector to the HDMI source (for example, to
control the Blu-ray player).
2. On the TP-752R :

Connect the HDMI OUTPUT to an HDMI acceptor (for example, a projector).

Connect the S/PDIF RCA connector to a digital audio acceptor (for example, an
AV receiver).

Connect the BAL. AUDIO 5-pin terminal block connector to a stereo balanced
audio acceptor (not shown in
Figure 3 ).

Connect the RS-232 9-pin D-sub connector to a controller (to control the Blu-ray
player on the transmitter side).
3. Connect the transmitter to the receiver via one of the following ways:

The CAT 5/6 RJ-45 connector, to via a CAT 5 cable.

The TERMINAL BLOCK 2-pin terminal block connector, to (not shown in
Figure 3 ).

The HD15 15-pin HD connctor, to (not shown in Figure 3 ).