Kramer Electronics Ltd.
TP-580CT
– Connecting TP-580CT
6
Connecting TP-580CT
Always switch off the power to each device before connecting it to your
TP-580CT
. After
connecting your
TP-580CT
, connect its power and then switch on the power to each device.
Figure 2: Connecting to the TP-580CT
To connect TP-580CT as illustrated in the example in
1. Connect a USB-C source (for example, a laptop) to the USB-C port
on the front
panel.
The USB-C port can provide power to the connected source or power the
TP-580CT
).
2. Connect the HDBT OUT port
on the
TP-580CT
to the HDBT IN port on the receiver
side (for example, Kramer
TP-580R
).
3. On the receiver side (
TP-580R
in this example) connect an acceptor (for example, a
display that is connected to the HDMI OUT connector).
4. Control the display on the receiver side:
▪
Connect a room controller (for example, Kramer
SL-240C
) to the RS-232 3-pin
terminal block connector
.
The display on the receiver side can be controlled by sending serial commands from
the controller via HDBT to the display.
▪
Connect an IR sensor to the IR 3.5mm mini jack
.
The display on the receiver side can be controlled by pointing the display IR remote-
control transmitter to the IR sensor. The IR signal passes, via HDBT to an IR emitter
that is connected to the display.
5. Connect the power adapter to
TP-580CT
and to the mains electricity.
1
6
7
8