KRAMER: SIMPLE CREATIVE TECHNOLOGY
Installing the TBUS-4 Table Connection Bus
8
5.3 Installing the Optional Insert Kit
An optional insert kit can be installed before or after installing the
TBUS-4
unit. The insert replaces one power module (see
Figure 3
).
To mount the insert, perform the following steps:
1. Unscrew the two screws that fasten the power module to the connecting
surface, keep the screws, and remove the power module from below.
2. Place and align the insert under the opening, insert the two screws to fix the
insert in place, and tighten them.
Figure 5: Optional Insert Kit
5.4 Installing TBUS-4 in the Cut-Out Opening
To install
TBUS-4
in the opening:
1. Remove the protective rubber guard from around the outer rim of the
mounting plate.
Beware of the sharp edge!
2. Carefully insert the unit into the prepared opening (see
Figure 6
).
3. Take the support brackets under the table and place them into the support
bracket grooves on both sides of the unit (see
Figure 2
).
4. Verify proper alignment of the unit before tightening the mounting screws.
5. Screw both mounting butterfly screws upward until they reach the table
surface (from underneath). Tighten firmly (see
Figure 6
).
6. Screw the locking butterfly screws downward until tight against the mounting
bracket.