Kramer RC-43T, Руководство пользователя, Страница: 12 / 18

RC-43T - Connecting the RC-43T 9
5.1 K-NET Wiring
The K-NET connector on the RC-43T must be connected to a room controller via a
four wire cable as shown in Figure 5 .
Figure 5: RC-43T K-Net Wiring
Note : The RC-43T is always device ID 2 on the K-NET bus and cannot be
changed.
To connect the RC-43T to a room controller:

Connect pin 1 on the K-NET connector to pin 1 on the room controller K-NET
connector (+12V to +12V)

Connect pin 2 on the K-NET connector to pin 2 on the room controller K-NET
connector (A to A)

Connect pin 3 on the K-NET connector to pin 3 on the room controller K-NET
connector (B to B)

Connect pin 4 on the K-NET connector to pin 4 on the room controller K-NET
connector (G to G)
5.2 Terminating the K-NET Bus
The devices at both ends of the K-NET bus must be terminated.