RC-206
Quick Start
P/N:
2 9 0 0 - 3 0 1 0 9 0 QS
Rev: 2
Scan for full manual
RC-206 Quick Start Guide
This guide helps you install and use your
RC-206
for the first time.
www.kramerav.com/downloads/RC-206
to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check w
hat’s in the box
RC-206
Ethernet and K-NET Control Keypad
1 Button-cap remover (tweezers)
Frame (or frame set) and faceplate
1 Set of button label sheets
1 Quick start guide
6 Button caps
1 Power adapter and cord
Installation accessories
Step 2: Get to know your RC-206
US-D Version
EU/UK Version
Front
Rear
Front
Rear
#
Feature
Function
1
Designed 1 Gang Wall
Frame
For fixing the
RC-206
to the wall. DECORA
™ design frames are included in US-D models.
2
Button Faceplate
Covers the button area after inserting the button labels.
3
Mounting Screw Holes
For securing the frame to the wall (US version only).
4
Configurable RGB Backlit
Buttons (6)
Configured to control the room and A/V devices.
Remove button covers to insert button labels (included).
5
Mounting Bracket
For fixing the frame to the in-wall box.
6
DIP-Switches
For K-NET: The last physical device on a K-NET bus must be terminated.
For RS-485: The first and the last units on the RS-485 line should be terminated. Other units
should remain unterminated.
DIP-switch 1 (to the left)
K-NET Line Termination
DIP-switch 2 (to the right)
RS-485 Line Termination
Slide down (ON)
For line termination.
For RS-485 line termination.
Slide up (OFF, default)
To leave bus unterminated.
To leave RS-485 line unterminated.
7
Ethernet RJ-45 Connector Connect to an Ethernet LAN for control, firmware upgrade and for uploading the configuration.
