Kramer RC-108, Руководство пользователя

Страница: 16 / 33

Configuring a TP-107AVR System
13
5 Configuring a TP-107AVR System
This section describes how to:
•
Connect the TP-107AVR (see section 5.1 )
•
Configure a TP-107AVR/TP-122 BoardView ™ kit (see section 5.2 )
•
Connect the RC-108 / RC-116 Presentation Controller to the
BoardView ™ kit (see section 5.3 )
•
Wire the CAT 5 LINE IN/LINE OUT RJ-45 connectors (see section
5.4 )
•
Connect via the K-NET terminal block connector (see section 5.5 )
•
Set the address number (see section 5.6 )
5.1 Connecting the TP-107AVR/TP-122 Transmitter/Receiver
System
To connect the TP-107AVR XGA/Audio Line Transmitter with the TP-122
XGA/Audio Line Receiver , as the example in Figure 9 illustrates, do the
following:
1. On the TP-107AVR , connect an XGA source (for example, a computer
graphics source) to the XGA IN 15-pin HD computer graphics connector
and an audio source to the audio IN
3.5mm mini jack, for example, using a
Kramer C-GMA/GMA cable (VGA 15-pin HD (M) + audio jack to VGA
15-pin HD (M) + audio jack)
1
.
2. On the TP-122 , connect the XGA OUT 15-pin HD (F) connector to the
XGA acceptor (for example, a display), and connect the AUDIO OUT
S/PDIF
RCA connector to the digital audio acceptor (for example, an AV
receiver), and the ANALOG 3.5mm mini jack to the analog audio acceptor
(for example, a stereo audio recorder).
3. Connect the LINE OUTPUT RJ-45 connector on the TP-107AVR to the
LINE IN RJ-45 connector on the TP-122 , via STP cabling
2
(with a range of
up to 300ft (100m)), see section 5.4 .
4. Connect a 12V DC power supply to each power socket on the TP-107AVR
and the TP-122 , and connect the power supplies to the mains electricity.
The signal from the XGA source is transmitted via CAT 5 cable, decoded
and converted at the XGA OUT 15-pin HD (F) connector to the XGA
acceptor.
1 Not supplied. The full list of Kramer cables is on our Web site at http://www.kramerelectronics.com . Alternatively, you can
connect an XGA source to the XGA IN 15-pin HD computer graphics connector, and a separate audio source to the AUDIO
IN 3.5mm mini jack
2 The Kramer BC-STP cable is recommended