Controlling the TP-107AVR
19
6
Controlling the TP-107AVR
The
TP-107AVR
can be used in a transmitter and receiver system as
described in section
, or set up as a controller-less system (see example
).
You can use the
RC-108
/
RC-116
(see section
) or any other RS-485
based controller
to control the
BoardView
™ system (see section
).
6.1
Controlling the TP-107AVR/TP-122 Kit via the RC-108
The
RC-108
unit, when connected to a chain of
TP-107AVR
units, controls
the system by granting access to the projector and overriding the individual
ONLINE buttons on the
TP-107AVR
units.
If a SELECTOR button on the
RC-108
is pressed and held for about two
seconds, the
RC-108
loses control over the
TP-107AVR
units in the chain.
To regain control, press and hold once again.
6.2
Controlling the TP-107AVR/TP-122 Kit via an RS-485 Controller
To control a
BoardView
™ via an RS-485 controller (see to section
for
the RS-485 communication Protocol), for example, the Kramer
RC-8IR
Room Controller
, connect the chain of
TP-107AVR
units to the RS-485
terminal blocks (see
).
1 For example, the Kramer RC-8IR Room Controller
2 Refer to the separate user manual, which can be downloaded at
http://www.kramerelectronics.com
Содержание RC-108
Страница 6: ...Getting Started 3 ...