KRAMER: SIMPLE CREATIVE TECHNOLOGY
The PT-110-od / TP-120-od Transmitter / Receiver Set
8
4.3 Connecting the PT-110-od / TP-120-od Transmitter / Receiver
You can use the
PT-110-od
XGA Line Transmitter
together with the
TP-120-od
XGA Line Receiver
to configure an XGA-to-Twisted Pair
Transmitter and Receiver system.
Before connecting the transmitter and receiver system you can acquire the
EDID (via PT-110-od) from the display or set the system to the default EDID,
see section
9
To
connect the
PT-110-od
XGA Line Transmitter
with the
TP-120-od
XGA
Line Receiver
, as the example in
Figure 3
illustrates, do the following:
1. On
the
PT-110-od
, connect the XGA source (for example, the 15-pin HD
output from a computer’s graphics card) to the XGA INPUT 15-pin HD
(F) connector.
2. On
the
TP-120-od
, connect the XGA OUT 15-pin HD (F) connector to
the XGA acceptor (for example, a display).
3. Connect the LINE OUTPUT RJ-45 connector on the
PT-110-od
to the
LINE IN RJ-45 connector on the
TP-120-od
, via CAT 5 cabling (with a
range of more than 300ft (>100m)), see section
8
.
4. On
both
1
the
PT-110-od
and the
TP-120-od
, connect the 12V DC power
adapter to the power socket and connect the adapter to the mains
electricity.
The signal from the XGA source is transmitted via CAT 5 cable, decoded
and converted at the XGA OUT 15-pin HD (F) connector to the XGA
acceptor.
5. If required, on the
TP-120-od
, adjust
2
the output signal level and/or cable
compensation equalization level.
1 For distances of up to 100 meters you can connect a power adapter to either the PT-110-od or TP-120-od. Above it, both
sides should be fed with power
2 Use a screwdriver to carefully rotate the trimmer, adjusting the appropriate level
