KRAMER ELECTRONICS LTD.
8
6
TYPICAL APPLICATIONS
IMPORTANT NOTE:
The built-in trimmers were factory pre-adjusted to assure 1:1
transparent operation. Readjusting the trimmers by the user can upset this transparency.
6.1
Typical Video Distribution
Figure 4 illustrates a typical setup of one of the distribution amplifiers described in this manual. An incoming
single input from a source (VCR) is split into two identical outputs, and connected to acceptors.
Perform the following steps (as necessary):
1) Connect the output of the video source to the video
INPUT
connector of the distribution amplifier(PT102V
in this case).
2) Connect
the
OUTPUTS
of the PT102V to the inputs of up to two video acceptors.
3) Operate the source, acceptors and the PT102V.
4) Use, only if necessary, the
GAIN
and EQ. trimmers to control the gain and cable Equalization of the video
outputs (see section
11.2
for more details).
Figure 4: Typical Video Distribution
