Connecting the PL-18 Control Port Expander
5
5
5
Connecting the PL-18 Control Port Expander
To connect the
PL-18
, as the example in
Figure 2
illustrates, do the
following
1
1. Connect the RS-232 ports as follows:
:
Connect RS-232/1 to a projector
Connect RS-232/2 to a PC, touch screen or an RC device
2. Connect the RELAY
2
Connect RELAYS 1 and 2 to window blinds
terminal block connectors as follows:
Connect RELAYS 3 and 4 to a screen
3. Connect the IR OUTPUTS as follows:
Connect IR OUTPUT 1 to a DVD
Connect IR OUTPUT 2 to a display
Figure 2: Connecting the PL-18 Control Port Expander
1 Switch OFF the power on each device before connecting it to your PL-18. After connecting your PL-18, switch on its power
and then switch on the power on each device
2 On each 3-pole terminal block connector, connect either: C to NO, or C to NC (C is common, NO is normally open
and NC
is normally closed)
im Vertrieb von CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203