WWW.KRAMERAV.COM
Step 4: Register the Receiver with the Transmitter
IR Remote Control
Front Panel Buttons
When purchased as a pair, the
KW-14T
and the
KW-14R
are delivered pre-registered. Registration needs to be performed only
when the transmitter or receiver is replaced or when adding additional receivers to a transmitter.
Note
: You can register up to four receivers with a transmitter.
To register a receiver with a transmitter using the front panel buttons
:
1. Press and hold the Register button on the receiver until the following message is displayed on the
OSD: "Please activate registration on Transmitter unit".
2. Press and hold the Register button on the transmitter until the following message is displayed on
the OSD: "Adding <Kramer 01>. Press OK to continue or EXIT to cancel".
3. Press the Register button on the receiver to confirm. The message "Adding <Kramer 01>…” and a
progress bar is displayed on the OSD while the registration process completes.
Note
: The registration process can take up to 60 seconds to complete.
You can register a receiver with a transmitter using either the buttons on the units or via the IR remote control.
To register a receiver with a transmitter using the IR remote control:
1. Connect and apply power to the transmitter, input source, receiver, and output acceptor.
2. Press the Add button on the IR remote control. The following message is displayed on the OSD:
“Please activate registration on Transmitter unit".
3. Press and hold the Register button on the transmitter until the following message is displayed on
the OSD:
"Adding <Kramer 01>. Press OK to continue or EXIT to cancel".
4. Press the OK button on the IR remote control to confirm.
The message "Adding <Kramer 01>… and a progress bar is displayed on the OSD while the
registration process is completing.
Note
: The registration process can take up to 60 seconds to complete. If the process takes longer
than this, power cycle both devices and then start the registration process from the beginning.
When the registration process is complete, the message and progress bar disappear from the
display. The Link and Video LEDs light solid.
5. Repeat steps 1 to 4 to register up to three more receivers to a transmitter.
Note
: Registration requires video disconnection
MENU
EXIT
SOURCE
OK
2
1
3
INPUT DEVICES
ADD
GUEST
DELETE