Kramer Electronics Ltd.
KN-DSP100
– Connecting KN-DSP100
6
Connecting KN-DSP100
Always switch off the power to each device before connecting it to your
KN-DSP100
. After
connecting your
KN-DSP100
, connect its power and then switch on the power to each
device.
Figure 2: Connecting to the KN-DSP100 Rear Panel
To connect KN-DSP100 (as illustrated in Figure 2):
1. Connect a laptop (for system control) to the RS-232 9-pin D-sub connector
.
2. Connect a keyboard and mouse to the USB ports
.
3. Connect the following ports to the Ethernet:
▪
LAN 1 RJ-45 port
to audio streaming via the Ethernet.
▪
LAN 2 RJ-45 port
to a network.
To operate
KN-DSP100
you need at least 1 Dante device connected to the system.
4. Connect the VGA 15-pin HD connector
to a display.
5. Connect the power cord to the power socket
and to the mains electricity.
We recommend that you use only the power cord that is supplied with this machine.