Kramer Galil 6-I, Руководство пользователя

Страница: 9 / 16

6 Galil 6-I - Installing the Galil 6-I 2-Way In-Wall Speakers
Keep this template for later use as a mask, as you may want to paint the speakers (see
Section
‎5.5
).
2. Mark the opening in the correct location by tracing the hole in the template
(either on the wall or the ceiling tile, see Section
‎5.2.1
for further
information).
3. Cut out a hole or small area within the marked template.
Initially, you can cut a smaller area inside the marked hole just to be sure that the area
behind the wall is clear. To do so insert a piece of
“L-shaped”‎wire into the smaller
opening and rotate it. If the wire hits any obstacle which prevents you from installing the
speakers, you will need to move the template and test the area behind the wall again.
4. Cut out the full-sized opening according to the template.
5.
Route‎the‎wiring‎from‎the‎amplifier‎to‎the‎speakers’‎cut out holes, taking
care not to place them next to electrical wires or at least at a distance of
about two feet from an AC line.
Do not nail or staple the speaker wires.
5.2.1 Cutting out a ceiling Tile
If you are mounting the speakers into a ceiling tile, remove the ceiling tiles where
you plan to install the speakers. Use the template to trace and then cutout the
speaker hole over an empty box.
Be sure that the tiles can support the speaker. Smaller sized tiles or
fiberglass-type tiles cannot support the weight of the speakers.
When this is the case, the speakers will need additional support.
5.3 Installing the Speakers
To install the speakers, do the following:
1. Remove the grille over the speakers by inserting a paper clip into one of the
grille openings and pulling it upward.
2. Position the mounting tabs (see Figure 3 ) inward.
!
i