Kramer 905xl, Руководство пользователя

Страница: 19 / 22

16 905xl - Protocol 3000
10.1.4 Entering Commands
You can directly enter all commands using a terminal with ASCII communications
software, such as HyperTerminal, Hercules, etc. Connect the terminal to the serial
or Ethernet port on the Kramer device. To enter
CR press the Enter key.
(
LF
is also sent but is ignored by command parser).
For commands sent from some non-Kramer controllers like Crestron, some
characters require special coding (such as, /X##). Refer to the controller manual.
10.1.5 Command Forms
Some commands have short name syntax in addition to long name syntax to allow
faster typing. The response is always in long syntax.
10.1.6 Chaining Commands
Multiple commands can be chained in the same string. Each command is
delimited by a pipe character (“|”). When chaining commands, enter the
message
starting character and the message closing character only once, at the
beginning of the string and at the end.
Commands in the string do not execute until the closing character is entered.
A separate response is sent for every command in the chain.
10.1.7 Maximum String Length
64 characters
10.2 Kramer Protocol 3000 Commands
Command Description
# Protocol handshaking
AUD-IN Switch audio only
AUD-IN? Read audio only
AUD Switch audio only
AUD? Read audio only
VOLUME Set simple audio volume
VOLUME? Read simple audio level
Increment audio volume
VOLUME– Decrement audio volume