CYLINDER ATTACHMENT TO
HEATER :
• Turn gas control knob clockwise to “ OFF”
• Remove base assembly door as show in Fig. 1.
Lift and rotate gas pressure regulator outwards
as show in Fig. 2.
Fig. 1
Fig. 2
• Attach cylinder to regulator inlet fitting by turning
cylinder clockwise as shown in Fig. 3. Push and rotate
gas cylinder downwards as shown in Fig. 4, till it is
vertically centered in the base assembly as shown in
Fig. 5.
Fig. 3
Fig. 4
CYLINDER REMOVAL :
• Lift and rotate propane cylinder as shown in Fig. 6.
Disconnect cylinder by turning it counter clockwise.
Fig. 5
Fig. 6
LOCATION –
FOR OUTDOOR USE ONLY:
• This outdoor patio heater is designed primarily for
temporary heating of outdoor areas such as patios, spas,
work areas and outdoor construction sites.
• The installation of your patio heater must conform with
local codes or, in the absence of local codes, with the
latest edition of National Fuel Code ANSI Z223.1. In
Canada, installation must conform to the current
CAN1-B149 INSTALLATION CODE.
• The minimum clearances to combustible materials
(shown below) must be maintained at all times.
LIGHTING INSTRUCTIONS :
1. Turn gas control knob clockwise to “ OFF” position.
2. Remove base assembly door.
3. Connect propane (
disposable
) cylinder to regulator inlet.
4. Push in and turn gas control knob counter clock-
wise to “ IGN/ON” until you hear the igniter click.
Pilot should light.
This will light the burner. If needed,
keep pressing and turning the control knob counterclockwise
until the burner lights.
3
CEILING/OVERHANG
10”
12”
30”