1 0
Figure 11-F -Removing
stove Knock-out panel
Installing Blower Accessory
BLOWER ACCESSORY 20-6028 FOR GSN3011,GSP3012 ,GSN3013,GSP3014
And 20-6029 FOR GSN2221,GSP2222
Remove the 3 screws from the
back, upper right hand corner or
the stove. Set these screws
aside.
Attach the Black L shaped
Bracket (Packed with the Stove)
to the back, upper corner using
2 of the screw s prev iously
removed.
Attach the Switch Box to the
Brac k et usi ng the s c r ew s
provided.
Next, remove the small rectan-
gular Panel on the back of the
stove (6 screws)
Attach the Temperature Sensor
to the 2 pre-drilled holes on the
inside, right top of the internal
firebox, using the 2 Black Screws
provided.
Attach the Fan unit to the Two
Silver Brackets on the Back
Panel that was removed in Step
3. (4 silver screws)
Run the wires from the Switch
Box through the hole on this Back
Panel.
Connect the 2 Yellow Wires from
the Switch Box to the 2 Terminals
on the Temperature Sensor.
Connect the Green Wire from
the Fan to the Green Wire from
the Switch Box.
Connect the one of the Black
Wires from the fan to the Black
Wire from the Switch Box and the
other Black Wire to the White
Wire. (Make sure these wires are
clear of the fan.)
Reattach the Back Panel using
the 6 screws removed earlier.
Attach the Round Switch Box
cover to the Back Panel using the
3 screws provided.
Plug the 3 prong grounded plug
into a nearby outlet.
WARNING:
1. ELECTRICAL GROUND-
ING INSTRUCTIONS: This appliance is
equipped with a three-prong ground-
ing plug for your protection against
shock hazard and should be plugged
directly into a properly grounded
three-prong receptacle.
2. Do not let the wires touch the re-
flect panel of the firebox, let the wires
of the motor and green wire through
the hole of the Knock-out panel.
NOTICE:
Shut off gas heater dur-
in g th e follo w in g b lo w er
installation.
Your blower is now available for
use. You can run it in manual
mode by simply turning the switch
from the middle position (OFF) to
Manual. The fan will operate until
you turn it off. Alternately you can
turn it to the Thermostat position.
In this case the fan will turn on
when the sensor warms from the
flame being on. It will turn off as
the sensor cools after the flame
has been off for awhile.
Figure 12-F -Removing
stove Knock-out panel
Figure 13-F -Attaching
Brackets To Blower
