20 FRAMING
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
#CLW-50 R.4 November 2019
3.8 Heat Distribution Cover Plates
IMPORTANT: Only remove the cover plates that are required specifically
for your application or installation.
3.8.1 Exterior and Interior Heat
Transfer Kit Cover Plates
Figure 3.8 shows removal of the Heat Transfer Kit cover plates. There
are (2) square cover plates located on the rear of the outer shell of the
appliance. This appliance can have (2) Heat Transfer Kits installed at
the same time. It can be up to two of the same heat transfer kit or a
combination of interior and exterior kits.
3.8.2 Komfort Zone Kit and Vented
Cavity Cover Plates
The Komfort Zone Kit and Vented Cavity design options have specific
framing requirements, mantel requirements, and exterior trim
dimensions. The appliance convection baffle and outer shell plates
must be removed for heat distribution required by cavity framing
designs.
1. Remove the (4) cover plates that correspond to the vented
cavity options for the front or top vented cavity. See Figure 3.9.
If planning to install a Komfort Zone kit, these (4) cover plates
will also have to be removed. See the #KZK-054 or #KZK-1510A
manual for further fireplace preparation.
Figure 3.8, Heat Transfer Kit Cover Plate Removal
Figure 3.9, Circle Cover Plate Removal
Remove (4) circle cover plates for a Komfort Zone Kit
or vented cavity options for the front or top vent cavity
Remove (1) square cover plate per kit, up to (2) kits may be used
See heat transfer kit manuals for more information