34
ELECTRICAL INFORMATION
9.3 #B36-LKT Optional Light Kit
ATTENTION: If converting to LP (propane) gas, do so now
before installing any media kit. Follow instructions included
with the conversion kit (sold separately).
CAUTION: Disconnect all electric power from fireplace before
performing any of these tasks.
NOTE: To avoid damage and prolong the life of halogen bulbs,
never touch with bare hands. Always use a soft cloth when
handling.
This kit includes:
(4) 20 Watt 120 V Halogen Bulbs
(1) Light Kit
(1) Rubber Grommet
(2 lb.) of Glass Media
(1) Bag of Klinkers
(2) Sheet Metal Screws
1. Remove the safety barrier and glass valance.
2. Remove the log set and refractory panels (if installed).
3. Remove the back log plate, burner assembly, and burner heat
shield.
4. Remove and save the (1) screw securing the access cover.
Remove access plate, and reinstall the (1) screw previously
removed.
5. Install the rubber grommet. Lead wires on the light bar
through the grommet.
6. Remove and save the (2) light kit mounting bracket screws on
the control board. Install mounting bracket using (2) screws
previously removed.
7. Connect the light wires to the light lead wires on the IFC
module. Apply high temperature sealant around the grommet
and wires to create an air-tight seal.
8. Secure the light housing with (2) screws (included).
9. Install (4) halogen bulbs into the lamp bases. Check bulbs
by turning the lights on by remote control. Unplug the IFC
module before continuing.
10. Reinstall the burner heat shield, burner assembly, and the
back log plate.
11. Reinstall the refractory panels (if used) and the ember panel.
12. Place glass media into the cavity in front of the burner
assembly.
13. Reinstall log set. Use a steel or stiff bristle brush to distribute
rock wool embers onto the logs and burner.
14. Reinstall the glass frame assembly and safety barrier.
• Halogen Bulb Access: To access the halogen bulbs for
replacement, slide the ember panel with the glass media
up past the front lip. Always use a soft cloth when handling
halogen bulbs.
Figure 9.2, Light Kit Installation
