34
FIREPLACE SETUP
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
#ALP-36 R.7 January 2020
8.0 FIREPLACE SETUP
8.1 Hearth Plate and Component
Access Doors
To access the toggle switch and remote learn button on the left side
of the unit, the hearth plate and component access doors must be
removed.
8.1.1 Installation
1. Install the glass frame assembly.
2. Locate the (4) slots on each side of the fireplace metal cabinet (2
each side).
3. Align the notched tabs on each component access door with the
slots on sides of the metal cabinet. Raise slightly into slots and
lower into position.
4. Install hearth plate. Set the long angled flange of the hearth
plate behind the access door handles to secure into place.
8.1.2 Removal
1. Remove hearth plate by lifting it up and out of the firebox.
2. Lift the component access doors up and out of slots.
Figure 8.1, Hearth Plate and Component Access Doors Installation and Removal
8.2 Glass Frame Assembly
WARNING: Do not operate this fireplace with the glass removed,
cracked, or broken. Replacement of the glass assembly should be done
by a licensed or qualified service person.
8.2.1 Remove Glass Frame Assembly
WARNING: Do not remove the glass assembly when hot.
1. Remove safety barrier.
2. Remove the hearth plate and component access doors.
3. Use a 7/16” nut driver to remove (3) nuts securing the bottom of
the glass valance.
4. Lift the glass frame assembly up and off (3) tabs located at the
top of the firebox.
8.2.2 Install Glass Frame Assembly
1. Align the slots on top of the glass assembly over the tabs at
the top of the firebox while lowering the bottom of the glass
assembly into position.
2. Secure glass frame assembly with (3) nuts previously removed.
3. Reinstall the hearth plate and component access doors.
4. Reinstall safety barrier.
ROTATE TOWARD CENTER
TO REMOVE AND INSTALL
COMPONENT
ACCESS DOOR
(1 SHOWN)
HEARTH PLATE
Figure 8.2, Glass Assembly Nut Location
NUTS SECURING
GLASS VALANCE
BOTTOM
