EX-02 ENDURO
•
Specific installation instructions
FOR KTM
FOR OTHER APPLICATIONS
Washers
Center piece
Bracket assembly
OR
2a
1
2
1
2
2b
4
5
4
6
1. Install the magnet and clip into the disc-brake.
2. Locate the speed sensor housing and screw on
the sensor until it is tight.
* Sensor and magnet must be max. 2-3 mm apart.
3. Secure the speed sensor cable (you might have
to use tye-wrap to hold it in place).
Magnets
For Kawasaki
Suzuki
Yamaha
Magnetic bolt
For Honda
1. Remove the plastic fork guard.
2. a - For Kawasaki, Suzuki, Yamaha: Insert
ONE
magnet into one of the the disc-brake bolts
head, the north face of the magnet (identified by a red line) must face the speed sensor.
2. b - For Honda: replace of the stock disc-brake bolt with the magnetic bolt.
* Sensor and magnets/magnetic bolt must be max. 2-3 mm apart.
3. Using brake-cleaner or any grease remover, clean the fork and wipe dry.
4. Install the speed sensor bracket as shown below.
5. Insert the speed sensor into the bracket housing and use the nuts to thighten them.
6. Secure the speed sensor cable (you might have to use tye-wrap to hold it in place).
7.
Place the fork guard back on (you might have to alter the guard so that the bracket can fit).
