wh053ba01a
4. Notes for assembling the aluminum alloy lid :
Step 1. Ensure
❷
the o-ring is inside
❶
the
aluminum alloy lid is placed at the
groove on the front end , confirm the
surface and the lid are correctly aligned to
prevent displacement of the o-ring, then press
and fix the lid onto the main body.
Step 2 . To ensure that the previous step is done
properly, wait for a few seconds for the standby
mode. When the LCD is off, fasten the inner
hexagonal screw. You have now successfully
replaced the battery.
The meter does not display properly.
Engine oil display error.
●Maybe the problem is caused due to insufficient power.
→Please change the internal battery.
●Maybe the problem is caused by incorrect battery installation.
→Please check is the battery direction is correct.
●Wrong bike model of motorcycle.
→Please check if the bike fits the dipstick.
※
If the problems still can’t be solved, please contact our techinical department.
.
The following situation do not indicate malfunction of the meter.Please check the following points,before contacting us.
Trouble
Check item
Trouble shooting
●Maybe the wire is not correctly connected,
→Please check if the wire is correctly connected.
●Incorrect reading caused by vibration.
→Due to engine vibration after starting, it can cause the oil surface to jump.
Thus the oil level may be incorrect.
M2 Socket Head Cap Screws
Aluminum alloy lid
Display panel and LCD assembly
Main body assembly
NOTE
Please refer to the diagram to disassemble.
And install according to the reverse order
of disassembly.
Do not use high-pressure water
stream to wash directly.
NOTE
While disassembling
❸ & ❹
. Do not
pull the wire, to prevent damage.
When fitting
❶
the LCD mirror surface lid with
❷
the main body and inner cap,please insert
the spring into the bracket and align it with the
sticking point for a firm structure.
2.
Please follow the steps below to install
the battery.
Step 1. Tilting the battery and place it
below
❶
the tab
.
Step 2. Press the battery downwards to
❷
the battery space, until the "click"
sound appear to settle the battery.
Step 3. Snap
the spring bracket with the
battery.
When low battery warning sy.bol appears,
battery replacement is needed immediately.
Please refer to the replacing
battery instruction above.
The warning symbol is illuminated.
The low battery warning symbols will
disappear after battery replacement.
1.
Please follow the steps below to remove
the battery (CR2032).
Step 1. Remove
❶
the spring bracket.
Step 2. Use flat head screwdriver push
❷
shrapnel
backwards.
Step 3. Whenthe tab is loose, remove
the battery.
3-1
3-2
3-3
44
Please, follow the steps below
Carefully remove the battery to prevent
breaking the tab.
Press and hold the main screen for 3
seconds to change the temperature unit.
