RK-100S Owner's manual
12
Controlling the pitch of the continuant
3
2
2
1
1. Select the program.
In this case, select a program where the sound does
not immediately decay to silence after a keyboard key
is pressed.
There may be no effect with a program where the
sound immediately decays to silence after a keyboard
key is pressed
2. While a sound is being produced, hold down the
LONG RIBBON PITCH button.
The PITCH button is lit up. Sound continues to be
produced while the button is held down.
3. Use the ribbon to control the pitch.
Slide your finger to the left and right along the ribbon
controller. With the original pitch at the location first
touched in the ribbon, raise and lower the pitch by
moving your finger in either direction.
Removing your finger from the ribbon will return the
pitch to the original setting.
Original pitch
4. Remove your finger from the button to stop the
continuant.
Controlling the pitch with your left hand free
3
2
1
1. While no sound is being produced, hold down the
SHIFT button and press the LONG RIBBON PITCH
button.
The PITCH button is lit up.
2. Play the keyboard.
Sound continues to be produced.
3. Use the ribbon to control the pitch.
See page 12 “Controlling the pitch of the continuant”
If the pitch was raised with the OCTAVE button, the
sound may be difficult to hear, depending on the area
used on the ribbon.
4. Press the PITCH button again to turn off the button
and stop the continuant.
Controlling the filter
As with pitch control, there are two control methods.
Tip:
The effects that can be controlled with the long ribbon
controller can be specified with the sound editor software
(when the RK-100S is connected to a computer via USB).
The filtering effect can be adjusted in the Long Ribbon section
of the sound editor software. In the Virtual Patch section, set
“Source” to “Long Ribbon”, and use “Destination” to specify
the parameters to be controlled. The parameters to be con-
trolled can also be specified with Fx Long Ribbon assignments.
Controlling the filter of the continuant
2
1
1
1. While a sound is being produced, hold down the
LONG RIBBON FILTER button.
The FILTER button is lit up.
Sound continues to be produced while the button is
held down.
2. Use the ribbon.
Slide your finger to the left and right along the ribbon
controller. With the original sound at the left end of the
ribbon, apply modulation by moving your finger to the
other end. Removing your finger from the ribbon will
return the sound to the original setting.
Original sound
Note:
The changes in the effect parameters differ depend
-
ing on the settings.
3. Remove your finger from the button to stop the
continuant.
