Korg Pandora PX5D, Руководство пользователя

Страница: 17 / 220

17
You can also adjust the settings so that the
π
/
†
CUR-
SOR will adjust the master level (
☞
p.18 “Specifying the
function of the Value encoder”).
Bypass/Mute
When you press the TAP/BYPASS button for approxi-
mately one second, the PX5D will be bypassed, and the
original sound will be dry (no effects). The effect chain
will blink, and the display will indicate “
BYPASS ” for
approximately one second.
If you press and hold the
TAP/BYPASS button for ap-
proximately two seconds, the output signal will be mut-
ed. The effect chain will blink rapidly, and the display
will indicate “
MUTE ” for approximately one second.
Bypass/mute will be turned off when you press the TAP/
BYPASS button once again. You can also return to Play
mode by pressing the EXIT button . Bypass or Mute can
also be entered from modes other than Play mode.
You can also activate Bypass or Mute using two foot
switches connected to the
PX5D (
☞
p.34 “ FOOTSW”).
Tuner
The tuner will operate when you bypass or mute.
meter
center mark
sharp
note name
calibration
1
Play a single string on your guitar or bass.
The LCD will show the note name and the calibra-
tion. If the pitch is more than a semitone higher than
the note name, a sharp symbol will appear at the
upper right of the note name.
2
The display area will act as a meter to show the pitch.
Tune each string of your guitar or bass so that the
indicator above the center mark is lit.
3
When you press either the TAP/BYPASS button , the
tuner (bypass/mute) will be turned off. You can also
return to Play mode by pressing the
EXIT button .
Calibration (Standard pitch A = 440)
You can use the Value encoder to adjust the calibration
in the range of A = 438 Hz–445 Hz . The calibration set-
ting you make will remain until the power is turned off.
Once the power is turned off, calibration will be reset to
A = 440 Hz .