Korg Nu:tekt OD-KIT, Руководство пользователя

Страница: 15 / 16

- 15 -
5. Mount the Nutube circuit board unit [17].
Peel off the release paper on
the double-sided tape of the
circuit board cushion (57) that
was attached to the Nutube
circuit board unit [17], and
mount the circuit board unit.
The Nutube circuit board
cushion is susceptible to heat,
and will melt if your soldering
iron touches it. Mount the
circuit board after you have
finished all of the soldering
work.
6. Connect the Nutube circuit board and the main circuit board with
harness A (52).
7. Solder harness B (53) to the foot switch [14].
Solder in order, while referring to the wiring
diagram.
8. Connect the foot switch and the main circuit
board with harness B (53).
9. Connect the LED and the main circuit board
with harness C (54).
10. Attach the battery cushion [14] into the
battery space.
foot switch
11. Connect the battery and fit it into the battery space.
Batteries are not included. You will need to purchase a commercially
available 9V alkaline battery (6LF22/6LR61).
12. Close the lower case [2], and secure it with the screws.
After attaching the Nutube bottom cushion [11] onto the inside of the
lower case, close the lower case and secure it with the case screws [3]
in four places.
Take care not to pinch the harness or other parts when closing the
case.
13. Attach the rubber feet [4] onto the lower case.
Attach the rubber feet and rating label onto the lower case.
14. Attach the volume knobs [5].
Mount the volume knobs onto their spindles.