Korg Nu:Tekt HA-S, Руководство пользователя

Страница: 6 / 16

- 6 -
Assembly
Preparing the main circuit board and Nutube circuit board
Parts List
1 Circuit board cushion PORON 7t, 8x19 1
2 Cushion N1 Sponge 1t, 5x40 2
3 Cushion N2 Sponge 1t, 5x15 1
4
Harness
-- 4
5 Hex spacers M2, L=3mm 2
6 Hex spacers M2, L=16mm 4
7 Internal tooth lock washers M2 4
8 Screws M2, L=5mm, Black 2
Building the Nutube circuit board unit
1. Peel off the release paper from one side of the circuit board
cushion (1), and attach it to the back side of the Nutube circuit
board.
Nutube circuit board
Circuit board cushion (1)
2. Attach the cushion onto the Nutube circuit board unit.
Attach cushion N1 (2) onto the edge of the Nutube circuit board. Attach
cushion N2 (3) onto both upper edges of the Nutube.
CushionN2 (3)
CushionN1 (2)
CushionN2 (3)
CushionN1 (2)
Do not cover
the connector
Attaching the Nutube circuit board unit
1. Connect the Nutube circuit board unit and the main circuit board
with the harness (4).
Do not use excessive force, as the wire can easily break. Also, do not
repeatedly connect and disconnect the harness.
2. Remove the release paper on the circuit board cushion (1) that you
attached to the Nutube circuit board, and attach the circuit board
unit to the main circuit board.
Make sure that the Nutube does not touch the adjacent parts or the
case.
(4)