Korg M3, Руководство по параметрам

Страница: 461 / 647

EQ and Filters (EQ/Filter)
451
a: OSC Mode
b: Note Interval
b: Note Fine
The OSC Mode parameter selects the oscillator operation
mode. When Note (Key Follow) is selected, the oscillator’s
frequency is determined based on the note number,
allowing you to use it as an octaver. The Note Interval
parameter sets the pitch offset from the original note
number by semitone steps. The Note Fine parameter allows
you to fine-tune in steps of cents.
d: Envelope Pre LPF
This parameter sets the upper limit of the frequency range to
which very low harmonics are added. Adjust this parameter
if you do not want to add lower harmonics to the higher
range.
015: Talking Modulator
This effect adds an unusual character, like a human voice, to
the input signal. Modulating the tone via dynamic
modulation, you can create an interesting effect that sounds
as if the guitar or synthesizer is talking.
c: Voice Top
d: Voice Center
e: Voice Bottom
These parameters assign vowels to the top, center, and
bottom position of the controller.
E.g.: When “Voice Top”=A, “Voice Center”=I, and “Voice
Bottom”=U:
If Sweep Mode is set to D-mod and Ribbon is selected as the
modulation source, moving your finger from the right to left
of the ribbon controller will change the sound from “a” to
“i,” then “u.”
If Sweep Mode is set to LFO, the sound will change
cyclically from “a” to “i,” “u,” “i,” then “a.”
f: Formant Shift
This parameter adjusts the frequency level to which the
effect is applied. If you wish to apply the effect to a higher-
range sound, set this parameter to a higher value; to apply
the effect to a lower-range sound, set this to a lower value.
f: Resonance
This parameter sets the intensity of resonance for the voice
pattern. A larger value will add more character to the sound.
f
Wet/Dry
Dry, 1 : 99...
99 : 1, Wet Sets the balance between the
effect and the dry input
Src Off...Tempo
Selects a modulation source for
Wet/Dry
Amt –100...+100
Sets the modulation amount
for Wet/Dry
a Sweep Mode D-mod, LFO
Switches between modulation
source control and LFO control
b
Manual
Voice
Control Bottom,
1...49, Center,
51...99, Top
Voice pattern control
Src Off...Tempo
Selects the modulation source
that controls the voice pattern
c Voice Top A, I, U, E, O
Selects a vowel sound at the
top end of control
p.451
d Voice Center A, I, U, E, O
Selects a vowel sound in the
center of control
p.451
e
Voice
Bottom
A, I, U, E, O
Selects a vowel sound at the
bottom end of control
p.451
f
Formant
Shift
–100...+100
Sets the frequency to which the
effect is applied
p.451
Resonance 0...100
Sets the Level of resonance of
the voice pattern
p.451
g
LFO
Frequency
[Hz]
0.02...20.00 Sets the speed of the LFO p.448
Src Off...Tempo
Selects a modulation source for
LFO speed
Amt
–20.00...
+20.00 Sets the modulation amount of
LFO speed
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Right
Wet / Dry
Wet / Dry
+
D -mod
Voice Top: A
Voice Center: I
Voice Bottom: U
A - I - U - E - O Talking Modulator
LFO
D-mod
LFO
Sweep Mode
h
MIDI Sync Off, On
When this is on, the LFO speed
is set by BPM, Base Note, and
Times, instead of Frequency
p.448
BPM
MIDI,
40.00...
300.00
MIDI syncs to the system
tempo; 40–300 sets the tempo
manually for this individual
effect
p.448
Base Note ...
Selects the type of notes that
specify the LFO speed
p.448
Times x1...x32
Sets the number of notes that
specify the LFO speed
p.448
i
LFO Type
Individual,
Common1,
Common2 Selects either (individual) LFO,
Common FX LFO1, or Common
LFO2
p.448
CmnLFO
Offset [deg]
–180...+180
Sets the phase offset when
Type = Common 1 or Common
2
p.448
j
Wet/Dry
Dry, 1 : 99...
99 : 1, Wet Sets the balance between the
effect and the dry input
Src Off...Tempo
Selects a modulation source for
Wet/Dry
Amt –100...+100
Sets the modulation amount
for Wet/Dry
+ Max
Zero
D -mod
– Max
Voice Bottom Voice Center Voice Top
U
I
A A
O
E
JS X
Ribbon
JS +Y
JS –Y
etc…
Zero
+ Max
Talking Modulator Control