Korg LED slider, Руководство по установке

Страница: 2 / 17

Introduction
Thank you for purchasing an LED slider upgrade kit for your ARP synthesizer.
These sliders not only look great, but they feel better than the original ARP
CTS sliders. This installation guide will show you how to install the slider
kit and the 5 volt power supply. For best results, this kit should only be
installed by qualified technicians. If you are unfamiliar with electronics,
please seek out the skills of a qualified technician who can install this kit.
The installation should take between 4 and 8 hours in most cases. Take your
time, and always check twice before drilling or soldering.
Kit Contents
• 5V 1.4A LED Ballast (1)
• LED Adapter PCBs - Standard Type (36 Avatar, 33 Odyssey)
• LED Adapter PCBs - Blinking Type (1)
• Short Jumper Cables
• Med Length Jumper Cables
• Long Jumper Cables
• Nuts (2)
• Bolts (2)
• Length of Red, Black, and Orange Wire
• Heat Shrink Tubing
• Female Connector Cable (3)
• Male Connector Cable (3)
• LEDs (37 Avatar, 34 Odyssey)
• LED Ballast Drill Tempate