95
Assembling the ST-8600Ci
stand
1. Open the packing carton and remove the con-
tents.
Check that all of the following items are present.
You will need a “+” (Philips) screwdriver to
assemble the stand.
2. Attach the side panel (left)
1
and side panel
(right)
2
to the pedal box
3
, and use four long
screws
5
to fasten them.
3. Attach the back panel
4
.
Use wood screws
7
to fasten the bottom edge
of the back panel
4
first (in five places). Then
use two wood screws
7
to fasten the sides (two
places on each side).
Use one wood screw
7
to fasten the cable
holder
9
to the back panel.
• At this time, make sure that there are no gaps
in the stand, and that it does not tilt.
4. Attach the piano.
Place the plastic feet located on the bottom of
the piano between the two brackets of each side
panel. Slide the piano forward so that the plas-
tic feet on the bottom of the piano contact the
front brackets.
From below, use two adjustable bolts
8
to fas-
ten the piano to the stand.
Caution
• Use two or more people to place the piano on
the stand.
• When placing the piano on the stand, be care-
ful not to pinch your hand.
• Be sure that the correct parts are assembled in
the correct orientation, and follow the steps in
the order that they are given.
• If you apply weight to the front edge of the
piano before tightening the screws, the piano
may fall down.
•Back Panel
4
•Side Panel
(Left)
1
•Pedal Box
3
•Side Panel
(Right)
2
•
Long screws
5
✕
4
(M6 x 16)
•
Adjustable bolts
8
✕
4
•
Adjuster
6
✕
1
•
Short screws
7
✕
10
(M3.5 x 16)
•
Cable holder
9
✕
1
•
In the plastic bag
3
1
5
2
•
Screw the Adjuster
6
into the Pedal
Box
3
until it is all the way in.
•
Pull out the Pedal Cord.
Rotate the adjuster so that it firmly con-
tacts the floor.
If the adjuster is not in firm contact with
the floor, the pedal will wobble and cause
malfunctions.
4
7
• Fasten the cable holder
9
together with the back panel.
• Finished surface toward the front.
8
8
•
Plastic feet
•
Bracket
Содержание Ci-8600
Страница 1: ...2 E Owner s Manual...