Chapter 2 Hardware Installation Page
7
Hardware Installation
Connect up
1.
Connect the Ethernet cable to the Ethernet Port in the bottom of the JetWave 2800. The
Ethernet port is an IEEE 802.3at compliant PoE port.
Figure 3 The Ethernet port in the bottom of the AP.
2.
To have better waterproof protection outside, please follow the below step to install the
Waterproof Cap for RJ-45.
Step 1: Insert the Ethernet Cable to the Waterproof Cap for RJ-45. You may re-assemble the
RJ-45 connector to insert the cap, make sure the cable distance from the PoE switch to the AP.
Check the cable connection is correct before installed it in the field.
Figure 4 Assemble the Ethernet Cable
Step 2: Put the red rubber ring to the RJ-45 connector first. Plug the Ethernet Cable into the
RJ-45 port. Note that the CAT 5E/6 cable is recommended.
