2. Preparation for Web management: Before you attempt to use the embedded web interface
for managing the switch operation, verify that your JetNet Managed Switch is properly
installed on your network and that every PC on this network can access the switch via the
web browser.
3. If you need to manage the switch by Telnet/SSH, please refer to the
JetNet 4518/5012G/5018G Manual.
Korenix Customer Service
KoreCARE is Korenix Technology’s global service center, where our professional staffs are
ready to answer your questions at any time.
Email address of Korenix Global Service Center: [email protected]
1.2 Give a name to the new console connection.
1.3 Choose the COM name, and select the correct serial settings. The serial settings of
Managed Switches are as below:
Baud Rate: 9600 / Parity: None / Data Bit: 8 / Stop Bit: 1
1.4 After connected, Switch login is requested. Type the username and password to login.
The default username is “admin”, password is “admin”.
1.5 Follow the manual to configure the software features.
2.1 Launch the web browser (Internet Explorer or Mozilla
Firefox) on the PC.
2.2 Type http://Device’s IP_Address (The default IP address
is 192.168.10.1.) then press Enter.
2.3 The login screen will appear next. Type in the
username and the password. The default username
and password is admin/admin.
2.4 Click OK, and then the welcome page of the
web-based management interface will appear.
2.5 At the left column of the web management interface
are the software features, ring column will list the available settings.
