Kooper 2193201, Инструкция пользователя

Страница: 15 / 16

14 15
1. Motor.
2. Place the rear motor assembly on the motor as shown.
3. Tighten the plastic nut clockwise.
4. Place the fans on the metal rod, making them coincide with the 2 openings on the metal rod.
Then tighten the cap anti-clockwise until it is tightened.
5. First place the coloured profile on the rear grille then attach the front grille and tighten the
screw appropriately to hold the decorative profile and the grilles.
ASSEMBLY
1. Fasten the tubes that make up the base to each other in the shape of a cross.
2. Insert the base cover into the white tube, then fasten this tube to the base with the 4 screws
provided and slide the base cover down.
3. Insert the extendible steel rod into the base.
4. Position the rod at the desired height.
5. Attach the top part of the fan with the motor to the metal rod through the ring.
6. Finally, mount the protective grilles and blades to the front of the motor:
• Engine and rear grille: match the 3 holes in the grille with the protuberances on the engine; fix
the 2 parts with the appropriate nut.
• Rear blade: fix the 2 parts by screwing the appropriate screw counterclockwise
• Rear grille - front grille: fasten together by means of the appropriate fastener
7. The fan operates at 3 different speeds.
8. It is possible to activate the oscillation of the blades.
9. You can tilt the blades as required.
OPERATING
• Make sure switch 0-1-2-3 (29) is set to 0. Connect the power cord (17) to a suitable socket.
• Set switch 0-1-2-3 to 1. The fan will run at low speed. Set the swi-tch 0-1-2-3 to 2. The fan will run at
medium speed. Set switch 0-1-2-3 to 3. The fan will run at high speed.
• Adjust the air flow by moving the motor casing (8) carefully upwards or downwards, having
previously loosened the knob that tightens the pin (15}. Tighten the screw again when the desired
position is obtai-ned.
• Do not use excessive force when moving the motor housing.
• By pressing the rocker switch (10) downwards, the fan oscillates left and right alternately. By
pulling the rocker switch fully upwards, the oscilation is stopped.
• Set switch 0-1-2-3 to 0 to turn off the fan.