Tips for ironing with professional results :-
Initially, to allow water to enter into the hose and iron, press the steam switch. This may take a few
seconds, then you will see the seam come out.
Begin to iron.
For best results, it is only necessary to press the steam switch for a few seconds at a time. It is not
necessary to activate the steam switch continuously.
There are several settings on your temperature dial. Recommended temperature settings are as
follows :-
#1, 2 – Preheat
#3
– Silk and delicate fabrics (low temperature)
#4
– Cotton and wool (medium temperature)
#5
– Linen (high temperature)
A telfon shoe is recommended to prevent garment shine and starch built-up.
When unattended or not in use, always turn off and unplug your iron.
TROUBLE SHOOTING GUIDE
PROBLEM
PROBABLE CAUSE
SUGGESTED REMEDY
Iron does not heat.
No power to iron.
Check electric outlet.
Temperature dial is in “OFF”
position.
Set temperature dial to No.3, 4
or 5.
Temperature dial is set on No.
1 or 2.
Set temperature dial to No.3, 4
or 5.
No steam or very little steam.
Little or no water in the bottle.
Fill water with bottle.
Bottle not high enough.
Bottle must be 36” above the
ironing surface.
Clogged filters.
Remove and rinse filter under
water faucet.
Clogged steam holes.
Clear holes with straightened
paper clip.
Iron spits water.
Iron is not hot enough.
Turn temperature dial up
(clockwise). Let iron heat up.
Steam switch held down too
long.
Release steam switch and let
iron heat up.
Iron too hot.
Temperature dial is set too
high.
Turn thermostat dial down
(counter clockwise).
Iron not enough hot.
Temperature dial is set too
low.
Turn thermostat dial up
(clockwise).
