EN
6
Regulatory compliance
The manufacturer hereby declares that product TT PMA
h10 is in accordance with the following requirements::
• European Low Voltage Directive 2014/35 / EU
• EMC directive for electromagnetic compatibility
2014/30 / EU
• Ecodesign Directive 2009/125 / EC
• RoHS Directive 2011/65 / EC
Fill in Water
• Disconnect the mains plug from the wall socket.
• The appliance can be opened only when the pressure
has been relieved. Unlock the lock by pushing it to
ON and holding it there. Then press down the steam
button.
• If the appliance is still warm, wait approx. 5 minutes
until removing the lid.
• Unscrew the lid anticlockwise to remove it.
• Pour any remaining water from the boiler in order to
avoid overfilling.
• Use the funnel to fill the boiler with a maximum of
approx. 250 ml of water.
• Attach the lid again by turning it clockwise.
The maximum filling capacity is approx. 250 ml. Use the
measuring cup provided. Use distilled water to prevent
calcification. Do not use battery water, water from
tumble dryers or water with additives such as cleaning
agents, alcohol, fabric softener or other chemicals. They
could cause hazards or damage to the appliance.
Electrical Connection
• Before inserting the plug into the socket. Make sure
that the mains voltage to be used matches that of the
device. You can find this information on the rating
label.
• Connect the device to a duly installed protective
contact socket.
Installation of Accessories
• Observe the arrow markings on both the appliance
and accessories.
• Insert the locking catches of the hose as far as they
will go into the connecting tip of the appliance.
Secure the hose by turning it clockwise (figure 1)
• Insert the locking catches of one of the attachments
as far as they will go into the connecting tip of the
hose. Secure the attachment by turning it clockwise.
• You may also connect the attachments directly to the
appliance. Connect as described above.
• Attach the angled nozzle or the circular brush on top
of the nozzle adapter, if required (figure 2)
• In order to clean sensitive surfaces, attach the fleece
cloth to the cleaning attachment (figure 3)
• In order to use the window cleaning attachment, hook
it into the cleaning attachment (without the fleece
cloth, figure 4).
Filling the Water Tank during operation
No steam will be discharged if the water tank is empty.
The water has to be filled up as follows:
• Remove the mains plug from the socket!
• Fill fresh water into the tank as described in the
chapter “Fill in Water”
• Connect the mains plug to the wall socket to continue
operation.
When you have finished using the Device
• Remove the mains plug from the socket!
• Let the unit cool down completely.
• Empty the water tank.
WARNING: Risk of scalding!
Keep the device straight. Tilting the device by more than
45° can cause hot water to leak from the device.
Caution
• Before you begin cleaning you should test the
materials to be cleaned as to their suitability for
cleaning with steam.
• Do not hold the steam nozzle for too long and too
close in one position.
• When the plug is connected to a wall socket, the
water in the boiler starts heating up. The heating
control lamp lights up.
• Pressure starts building up in the boiler after
3-4minutes. When the appliance is ready for use, the
control lamp turns off.
• Unlock the lock by pushing it to ON and holding it
there. Then press down the steam button to generate
pressure.