Kontron KFM21_e, Руководство пользователя

Страница: 24 / 35

Installation Instructions
Assembly into a Control Panel
At the back side of the monitor KFM21_e there are 16 threaded bolts (each four
bolts on every side) used for installation into a control panel or other cabinet.
A cutout and 16 drill-holes (Ø 7.5 mm) corresponding the dimension in the hole
pattern, have to be prepared first for a panel installation. The monitor will be
tighten using the 16 M5 nuts and the 5.3 mm washers. Before bolt together,
remove the rubber seal protection foil on the rear side of the front panel. The
contact surface with the rubber seal must be clean and appropriately flat. The
front of the KFM21_e is sealed in accordance with IP65).
Fig. 9: Hole pattern for KFM21_e mounting
(all value in mm)
21.3" Industrial LCD Monitor KFM21_e – User’s Manual (Version 2.00) 23