CP6006-SA – User Guide, Rev. 0.5 Preliminary
// 68
6.3.2.
Hot Swap Removal
Prior to following the steps below, ensure that the safety requirements are met. When removing a board from the
system, particular attention must be paid to the components that may be hot, such as heat sink, etc.
To remove the CP6006(X)-SA from a running system proceed as follows:
1.
Unlock the board ejection handles by pressing their release buttons.
The blue HS LED starts blinking indicating that the shutdown process has begun.
2.
After approximately 1 to 15 seconds, the HS LED turns on steady indicating that the CP6006(X)-SA may be
removed from the system.
3.
Disconnect any interfacing cables that may be connected to the board.
4.
Unscrew the front panel retaining screws.
5.
Using the ejector handles, disengage the board from the backplane and remove it from the system.
Содержание CP6006-SA
Страница 1: ... USER GUIDE www kontron com 1 CP6006 SA User Guide Rev 0 5 Preliminary Doc ID To be Determined ...
Страница 19: ...CP6006 SA User Guide Rev 0 5 Preliminary www kontron com 19 Figure 4 4 HP CP6006X SA Front Panel Top View ...
Страница 20: ...CP6006 SA User Guide Rev 0 5 Preliminary www kontron com 20 Figure 5 4 HP CP6006 X SA Front Panel Bottom View ...
Страница 72: ...CP6006 SA User Guide Rev 0 5 Preliminary www kontron com 72 7 uEFI BIOS t b d ...
