Kontron CP3002, Руководство пользователя

Страница: 73 / 152

CP3002 Installation
ID 1042-9252, Rev. 2.0 Page 3 - 5
P R E L I M I N A R Y
3. Using the ejector handle, engage the board with the backplane. When the ejector han-
dle is locked, the board is engaged.
4. Fasten the front panel retaining screws.
5. Connect all external interfacing cables to the board as required.
6. Ensure that the board and all required interfacing cables are properly secured.
The CP3002 is now ready for initial operation. Except for the uEFI BIOS, at this point there is
no other software installed. For software installation and further operation of the CP3002, refer
to appropriate CP3002 software (uEFI BIOS, BSP, OS), application, and system documenta-
tion.
3.3 Standard Removal Procedures
To remove the board proceed as follows:
1. Ensure that the safety requirements indicated in Chapter 3.1 are observed. Particular at-
tention must be paid to the warning regarding the heat sink!
2. Ensure that no power is applied to the system before proceeding.
3. Disconnect any interfacing cables that may be connected to the board.
4. Unscrew the front panel retaining screws.
5. Disengage the board from the backplane by first unlocking the board ejection handle and
then by pressing the handle as required until the board is disengaged.
6. After disengaging the board from the backplane, pull the board out of the slot.
7. Dispose of the board as required.
Warning!
Care must be taken when applying the procedures below to ensure that
neither the CP3002 nor system boards are physically damaged by the
application of these procedures.
Warning!
Even though power may be removed from the system, the CP3002 front
panel cables and, when installed, the RIO transition module front panel ca-
bles may have power applied which comes from an external source.
In addition, these cables may be connected to devices that can be dam-
aged by electrostatic discharging or short-circuiting of pins.
It is the responsibility of the system designer or integrator to ensure that
appropriate measures are taken to preclude damage to the system or inju-
ry to personnel which may arise from the handling of these cables (con-
necting or disconnecting).
Kontron disclaims all liability for damages or injuries resulting from failure
to comply with the above.
Warning!
Due care should be exercised when handling the board due to the fact that
the heat sink can get very hot. Do not touch the heat sink when changing
the board.