Kontron CP-RIO6-001, Руководство пользователя

Страница: 50 / 52

Installation CP-RIO6-001/-DD-216/-HD/-HD-216
Page 3 - 6 ID 1043-5620, Rev. 2.0
3.4.2 USB 2.0 NAND Flash Module Installation
One USB 2.0 NAND Flash module may be connected to the CP-RIO6-001/-DD-216/-HD/-HD-
216 via the onboard USB 2.0 NAND Flash connector, J18.
The USB 2.0 NAND Flash module must be physically installed on the CP-RIO6-001/-DD-216/
-HD/-HD-216 prior to installation of the rear I/O module in a system.
During installation it is necessary to ensure that the USB 2.0 NAND Flash module is properly
seated in the onboard USB 2.0 NAND Flash connector, i.e. the pins are correctly aligned and
not bent.
If this module is ordered separately, it is delivered with two screws and a standoff to assemble
the module to the CP-RIO6-001/-DD-216/-HD/-HD-216. To do this, first install the standoff,
then mount the module itself and fixate it with the second screw.
Refer to Figure 3-1 for placement of the USB 2.0 NAND Flash module.
3.4.3 Installation of an External Serial ATA Device
One external SATA device may be connected to the CP-RIO6-001/-DD-216/-HD/-HD-216 via
the onboard SATA connector J17 as well as the appropriate SATA cable.
Some symptoms of incorrectly installed SATA devices are:
• Device on a SATA channel does not spin up: check power cables and cabling. May also
result from a bad power supply or SATA device.
The SATA connector on the CP-RIO6-001/-DD-216/-HD/-HD-216 provides only a data
connection. The power for this device must be supplied by a separate connector. For
further information, refer to the respective documentation of the device.
• SATA device fail message at boot-up: may be a bad cable or lack of power going to the
drive.
Note ...
Only qualified USB 2.0 NAND Flash modules from Kontron are authorized for
use with the CP-RIO6-001/-DD-216/-HD/-HD-216. Use of unqualified USB 2.0
NAND Flash modules or improper installation will void the warranty and may
result in damage to the CP-RIO6-001/-DD-216/-HD/-HD-216 or the system.
Warning!
The incorrect connection of power or data cables may damage the SATA
device and/or the CP-RIO6-001/-DD-216/-HD/-HD-216.