P R E L I M I N
A R Y
29
www.kontron.com
User Guide
COMe Ref. Carrier-i T6 TMI
2.3.15 Power Supply and Management
The COMe Ref. Carrier-i T6 TMI supports fixed input voltage (12V only) as a standard feature via the DC
jack, J6.
Note:
The COMe Ref. Carrier-i T6 TMIP (Professional) version also supports a wide input voltage
range (8.5V - 30V) by default via a wired power connector, J1. The COMe Ref. Carrier-i T6
TMIP can be powered up either through the J1 or the J6 connector.
Warning:
Powering up the COMe Ref. Carrier-i T6 TMIP through power both connectors (J1 and J6) at
the same time may result in damage to the power supply unit/power adapter.
The following 12V power supply unit is recommended for use with the COMe Ref. Carrier-i T6 TMI:
»
DELTA ELECTRONICS. MDS-150AAS12B
The following figure and table provide pinout information for the wired power connector, J1.
Note:
The rapid shutdown feature is only available on the COMe Ref. Carrier-i T6 TMIV (Value) and
the COMe Ref. Carrier-i T6 TMIE (Entry) versions if rapid shutdown is supported by the COMe
module used and enabled via the onboard DIP switch, SW1.
The following mating power connectors are recommended for use with the COMe Ref. Carrier-i T6 TMI:
»
Wurth Electronics, Part Numbers: 691361100004 / 691363110004
»
TE Connectivity AMP Connectors, Part Numbers: 284506-4 / 1986692-4 / 1986693-4
2.3.16 RTC
The COMe Ref. Carrier-i T6 TMI provides a 2-pin connector, J36, for an external CMOS battery. In addi-
tion, the following versions provide a goldcap, C35, for RTC backup:
»
COMe Ref. Carrier-i T6 TMIP (Professional): 2.5F goldcap
»
COMe Ref. Carrier-i T6 TMIV (Value):
1.5F goldcap
Figure 15: Power Connector J1
1
4
J1
Table 17: Power Connector J1 Pinout
PIN
SIGNAL
1
V_IN
2
V_IN
3
GND
4
GND
