Kontron AT8060, Руководство пользователя

Страница: 43 / 160

28 AT8060
www.kontron.com
4. Management
4.1 Hardware Management Overview
The purpose of the hardware management system is to monitor, control, ensure proper operation and
provide hot swap support of ATCA Boards. The hardware management system watches over the basic health of
the system, reports anomalies, and takes corrective action when needed. The hardware management system
can retrieve inventory information and sensor readings as well as receive event reports and failure
notifications from boards and other Intelligent FRUs. The hardware management system can also perform
basic recovery operations such as power cycle or reset of managed entities.
4.2 Configuring LAN interface
Before connecting to the Management Interface, the Management IP address needs to be confirmed. To
obtain the address or configure it:
• Enter the BIOS Setup.
• Go to Set BMC network configuration menu, which is located under “Server Mgmt”.
• Choose the LAN channel to be configured.
• Select state and IP source (static or dynamic).
• When selecting IP source static, select IP Address, Subnet Mask and Gateway Address.
• Set LAN channel IP Address source, IP Address, Subnet Mask and if required, the Gateway address on the
corresponding menu.
4.3 Web Management Interface
4.3.1 Connecting to the Web Management Interface
To have access to the Web Management Interface, at least one of the IPMC LAN interfaces must be configured
and accessible over the Base interface.
To access the Web Management Interface:
• From a remote system, open a web browser.
• Type the IP address of the management controller in the browser.
• Default username and password are admin / admin.
Note:
A maximum of 4 sessions can be opened simultaneously. Up to 5 users can be configured. An
automatic logout will be done after 5 minutes of inactivity.