886LCD/ATX(GV) -/ATXU(GV)
KTD-00647-C
Public User Manual
Date: 2007-02-08 Page
10 of 71
3. System
specification
3.1 Component main data
The table below summarises the features of the 886LCD-GV embedded motherboards.
Form factor
886LCD/ATXU(GV): uATX (244,1 x 305,0 mm)
886LCD/ATX(GV): ATX (190,5 x 304,0 mm)
Processor
•
Support for Intel® Pentium® 4, Intel Celeron® and Intel® Celeron® D Processors
in mPGA478 socket with 400MHz/ 533MHz system bus.
•
0.13 micron and 90nm Architecture support
•
L2 cache: 128KB, 256KB and 512KB
Memory
•
2x184pin DDR SDRAM Dual Inline Memory Module (DIMM) sockets.
•
Support for DDR 266 (PC2100). DRAM supporting higher speeds: DDR 333
(PC2700) and DDR 400 (PC3200) may be used after qualification testing.
•
Support for up to 2GB of system memory
•
ECC not supported
Chipset
Intel 845GV Chipset consisting of:
•
Intel® 82845GV Graphics and Memory Controller Hub (GMCH)
•
Intel® 82801DB I/O Controller Hub 4 (ICH4)
•
4 Mbit Firmware Hub (FWH) for BIOS
Video
•
Intel Extreme Graphics controller
•
Video memory support: maximum 64MB with more than 128MB DDR SDRAM
installed.
•
The GMCH has an integrated 350 MHz RAMDAC that can directly drive a
progressive scan analog monitor up to a resolution of 2048x1536 at 60 Hz.
•
The GMCH provides two multiplexed
Digital Video Out Ports
(DVOs) through the
onboard
AGP 2.0, 1.5V connector
that are can drive a 165 MHz pixel clock.
o
DVI DVO ADD, CRT DVO ADD and LVDS DVO ADD cards supported
Note: Only ADD cards are supported , AGP cards are not supported.
Audio
Audio, AC97 version 2.3 subsystem using the Realtek ALC655 codec
•
Line-out
•
Line-in
•
CDROM
in
•
Microphone
I/O Control
Winbond W83627HG LPC Bus I/O Controller
Peripheral
interfaces
•
USB host interface; 3 host controllers and supports 6 USB ports; includes a EHCI
high-speed 2.0 USB controller. USB legacy keyboard function supported.
•
Two Serial ports (RS232). Port 2 can be set to operate in normal, IrDA or ASKIR
mode
•
One Parallel port, SPP/EPP/ECP
•
One Floppy port
•
Two Serial ATA 150 IDE interfaces.
•
Two Parallel ATA IDE interfaces with UDMA 33, ATA-66, ATA-100 support
•
PS/2 keyboard and mouse ports
•
Game/Midi
port
LAN Support
1x 10/100Mbits/s LAN subsystem using the Realtek RTL8100C LAN controllers.
PXE netboot supported. Wake On LAN (WOL) supported.
BIOS
•
Kontron Technology / AMI BIOS (core version 8.00)
•
Support for Advanced Configuration and Power Interface (ACPI 1.0, 2.0), Plug and
Play
o
Suspend To Ram
o
Suspend To Disk
•
SW Watchdog not supported by BIOS
•
Secure CMOS/ OEM Setup Defaults
•
“Always On” BIOS power setting
•
SATA RAID Support (RAID modes 0 and 1)
