Fault and troubleshooting
Storage, disposal
Store the table monitor stands in a dry place.
Recycle disassembled components:
u
Scrape all components made of metal.
u
Recycle or reuse all plastic, paper, and cardboard components.
u
Sort all other components according to material composition and dispose of them
u
according to local regulations.
Contact information
KÖNIG & MEYER GmbH & Co. KG
Kiesweg 2 Phone: 09342/8060 E-Mail: [email protected]
97877 Wertheim Fax: 09342/806-150 Web: www.k-m.de
Germany
26773-000-56/76/87 Rev.04/06/02 03-80-859-00 4/21
Fault/cause
Check/Remedy
Stand wobbles
● Check the surface for dirt or unevenness.
● Check for correct fitting of the rubber pads.
Assembly
To assemble the table monitor stand, proceed as follows :
1.) Unpack and check item for damage and completeness
Maintenance, cleaning and repair
u
Maintenance:
Check the position of the loudspeaker at regular intervals.
u
Cleaning:
Use a slightly damp cloth to clean the table monitor stand.
u
Do not use chlorinated or abrasive cleaning agents. These will cause damage to the surface
u
and varnish.
u
Repair:
If any parts are missing, contact the manufacturer at www.k-m.de. Here you can find a
u
corresponding spare parts list by entering the article number on the type label. Use this page
u
to reorder missing or damaged components.
2x »Z-Stand«
4x4 self-adhesive rubber pads
Stick respectively four rubber pads under-
neath the stand and four on the bearing plate.
The position of the rubber pads on the bearing
plate depends on the size of the speaker used.
Place the speaker centrally on the table stand.
This is the only way to ensure a stable and
secure stand.
!When placing the loudspeaker, there is a danger of crushing between the components!
