Technical data
Assembly
!There is a risk of crushing between the components due to the adjustment option!
Unpack and check item for damage and completeness.
The tablet PC stand holder is fully assembled.
Mounting on a stand:
When screwing on the tablet PC stand
holder, make sure that it does not twist. Screw the tablet PC
stand holder hand-tight to the used stand.
Insert and position the tablet:
Open the clamping nut on the slider and pull the slider
upwards. Place the tablet on the lower support arms.
Make sure that the back of the tablet is against the
holder, place the slider on the tablet with a little pressure
and tighten the clamping nut hand-tight. The second
hole can be used to further adjust the clamping range.
This may be necessary for smaller devices or if the
tablet is to be inserted crosswise. To do this, unscrew
the clamping nut and remove it together with the was-
her. Insert the screw into the free hole and tighten the
washer together with the clamping nut. The inclination
can be adjusted using the clamping nut on the holder.
To do this, open the clamping nut, adjust the position
and hand-tighten the clamping nut again.
Material
Screws, washer, threaded bolt, thread adapter, nut: galvanised steel
Holder, upper joint part, lower joint part, clamping screws: black plastic
Load capacity
Tablets
Dimensions and
adjustment range
210 x135 x 100 mm
Tablet clamping range: Upper hole: 185-307 mm
Tablet clamping range:
Lower hole: 155-277 mm
Inclination: 90°
Packaging
254 x 150 x 104 mm
Weight
0.334 kg
