Technical data
Assembly
!There is a risk of crushing between the components due to the adjustment option!
Unpack and check item for damage and completeness.
The tablet PC holder is fully assembled.
Mounting on a stand:
To mount the tablet PC holder on a
stand, unscrew the clamping screw on the prism until the tube
fits into the prism. Attach the holder to the desired position and
hand-tighten the clamping screw again.
Insert and position the tablet:
Open the clamping nut on the slider and pull the slider
upwards. Place the tablet on the lower support arms.
Make sure that the back of the tablet is against the
holder, place the slider on the tablet with a little pressure
and tighten the clamping nut hand-tight. The second
hole can be used to further adjust the clamping range.
This may be necessary for smaller devices or if the
tablet is to be inserted crosswise. To do this, unscrew
the clamping nut and remove it together with the was-
her. Insert the screw into the free hole and tighten the
washer together with the clamping nut. The inclination or
direction can be adjusted using the two clamping nuts
on the holder. To do this, open one of the two clamping
nuts, adjust the position and hand-tighten the clamping
nut again.
Material
Clamping prism: steel powder-coated, black
Screws, washer, threaded bolt, nut: galvanised steel
Holder, upper joint part, lower joint part, clamping screws: black plastic
Load capacity
Tablets
Dimensions and
adjustment range
220 x 203 x 100 mm
Tablet clamping range: Upper hole: 185-307 mm
Tablet clamping range:
Lower hole: 155-277 mm
Inclination: 90º
Panning: 235° or 360
Prism clamping range: 7-30 mm
Packaging
254 x 150 x 104 mm
Weight
0.58 kg
