6. MOUNT SCREEN/MONITOR
Set of screws
M6 or M8
In the case of inset
threaded holes on
the Screen/Monitor:
(“Crater": Depth >
2 mm / ø > 15 mm).
Mount the plastic
connectors to the
front.
6.a MOUNTING STRIPS to SCREEN
Mounting strips
3
fastened with
2 screws respectively to the
back of the monitor/screen.
Possible distance
see below: 5.a
6.b VERTICAL TUBES to STAND
Verticale tube
5
fasten with
2 screws
11-14
respectively
to the plate of the stand.
(Torque: max 4 Nm)
First unscrew the cylinder screws
5a
from the 4 nut slots then:
6.c Mount the
6.c
SCREEN/MONITOR
on the vertical tube
5
of
the stand.
Z
Set the NUT SLOTS
and the
MOUNTING STRIPS
to the VERTICAL TUBE
and tighten:
6.d Mount the
6.d
SCREEN/MONITOR
6.d
on the Stand
Place the key SW3
18
in the hexagonal
hole and move the nut slot, until the disk
15
and the M6 x 16 mm
5a
screw are set
and can be screwed together with SW5
key
17
(Torque: max 6 Nm)
Required thread distances of the Screen/Monitor according to
VESA MIS-F: - 300-800 mm horizontal
VESA MIS-F:
- 200-500 mm vertical
