24120 Speaker Wall Mount
- for loudspeakers up to max. 50 kg
- equally suited for the following areas: domestic, building or public
- with a patented expanding mandrel for a wobble-free speaker fit
- suitable for flange bushing with an internal diameter of 35-37 mm
- the arm is inclinable from 0° to 22° (in 10 steps)
- the direction of the loudspeaker is variable by means of the
-
expanding mandrel
SAFETY NOTES
INSTALLATION INSTRUCTIONS
1. COMPONENTS
(a. - g.)
2. ASSEMBLY
- Before and after use check the wall mount for damages.
-
Damaged parts must not be used.
- Do not exceed the max. centric load of 50 kg.
- Not suitable for outdoor or moist areas.
- Observe locally valid mounting instructions
-
(possibly deviating from examples given in chapter
4.A
,
B
,
C
).
- Use 6 screws for wall mounting.
- Installation should only be carried out by trained personnel.
- Mounting only on suitable wall with appropriate mounting material
-
(not included).
- Unstable walls or electrical or water lines and such like lying behind plaster
-
are unsuitable.
-
When in doubt, please consult a qualified specialist.
- Check at regular intervals strength and condition of the components and
-
the screw connections.
- Careful handling is necessary since the adjustability hides pinch point hazard.
- When using the bracket in "event and production facilities for scenic
-
representation" correspondenting accident prevention regulations are valid.
Work with due care during installation. In particular tipping or dropping of components should be avoided.
If necessary, work with more than one person. The order of the three screw fittings is not mandatory.
1. COMPONENTS
Many parts of the holding are already pre-assembled.
Please remove the following from the package:
a.
Wall bracket with support tube
b.
Support bracket
c.
Arm with u-strap and expanding mandrel
as well as the accessory bag with:
d.
Hexagon bold M6 x 60 mm (3x)
e.
Lock nut M6 (3x)
f.
Washer ø6,4/12 mm (6x)
g.
Protective cap for M6 (8x)
Please carry out a visual inspection to make sure that all parts are
complete and alright, if identifiable.
Thank you for choosing this product. Please read and follow carefully the
instructions. They inform you about all the important steps regarding set-up and
handling. We recommend to keep the instruction for future reference.
2.1
Lay out the wall bracket
a
on a level surface
2.4
Slide washers on
threaded pins
2.5
Tighten lock nuts M6
(SW10)
2.6
Press on protec-
tive caps (8x)
2.2
Place one washer
f
on each of the
three hexagon screws
d
2.3
With the screws
d
now establish
these three connections:
2.3.1
Arm
c
with support bracket
b
2.3.2
Arm
c
with support tube
a
2.3.3
Support bracket
b
with support tube
a
support tube
arm mandrel
support bracket
